Alpha Suite Inc.

info@alphasuite.com

  • ASI GAS SAMPLING
  • IN-SITU DILUTION
  • DILUTION PROBE HEATER
  • EX-SITU DILUTION
  • CRITICAL ORIFICES
  • GAS DILUTING SAMPLER
  • DIRECT EXTRACTIVE
  • PARTS & SERVICE
  • ABOUT US
  • CONTACT
  • More
    • ASI GAS SAMPLING
    • IN-SITU DILUTION
    • DILUTION PROBE HEATER
    • EX-SITU DILUTION
    • CRITICAL ORIFICES
    • GAS DILUTING SAMPLER
    • DIRECT EXTRACTIVE
    • PARTS & SERVICE
    • ABOUT US
    • CONTACT
Alpha Suite Inc.

info@alphasuite.com

  • ASI GAS SAMPLING
  • IN-SITU DILUTION
  • DILUTION PROBE HEATER
  • EX-SITU DILUTION
  • CRITICAL ORIFICES
  • GAS DILUTING SAMPLER
  • DIRECT EXTRACTIVE
  • PARTS & SERVICE
  • ABOUT US
  • CONTACT

Dilution Probe Heaters - DP-060 Series

Overview

The ASI Model DP-060 Series Probe Heater is specially developed for use with new ASI or existing EPM In-situ Diluting Samplers (Dilution Probes). Whether you are looking for a basic coil replacement, or a complete heater assembly, our pricing is significantly lower than that of the formerly available EPM models. Another simple and low cost way to keep your CEMS sampling equipment downtime to a minimum.

Whether your using a dilution probe heater or your probe is unheated, we can guide you through the installation process so you can use your existing extension pipe. For new installations we offer design guidance for special configurations custom weldments and adaptors. Did you know we also have a Stack Tester Version of our probe heater? Check out our brochure at the bottom of this page for details.

Key Features

  • Lighter:  Assembly with extension pipe will be much lighter as it will use 3" nominal pipe (3-1/2" OD) instead of 3-1/2" nominal pipe (4" OD) as with the EPM model 797.561L. Check out our "Stack Tester" versions, they use a 1-1/2" nominal pipe (1.90" OD)!!
  • Compact:  Can fit into smaller ID stack/duct ports, as the extension ring does not exceed the extension pipe OD of 3-1/2". The EPM model has and extension ring with a 5" OD.
  • Compatible:  Can be used with existing in-situ dilution probes regardless of probe-flange type, as long as the probe has newer style filter cap assembly (with groove for the Kalrez® O-ring at probe-tip).
  • Adaptable:  Custom adaptors can be produced to attach heated probe assembly to many existing extension pipe configurations. Also, has three tapped holes on tip face of outer heater mantle, that can be used to attach particulate deflector if desired (custom made by end user, or designed by ASI upon request).
  • Interchangeable:  The heater coils are interchangeable between this heater assembly and the EPM 797.560 series heaters.
  • Economical:  Whether you are looking for basic Coil Replacement, or a complete heater assembly, our pricing is significantly lower than that of the formerly available EPM models.

PDF Viewer

Download PDF
  • ASI GAS SAMPLING
  • IN-SITU DILUTION
  • DILUTION PROBE HEATER
  • EX-SITU DILUTION
  • CRITICAL ORIFICES
  • GAS DILUTING SAMPLER
  • DIRECT EXTRACTIVE
  • PARTS & SERVICE
  • ABOUT US
  • CONTACT

Alpha Suite Inc.

info@alphasuite.com (847) 788-9489

Copyright © Alpha Suite Inc. - All Rights Reserved.

Powered by