- Spare Parts
EPM Probe Heaters -
O-Ring -- P/N GS-K118:
Kalrez® | Max. Temp.
Description: For use with the heated in-situ diluting
sample probes (located at probe tip for front seal). For the
Kalrez® O-ring used in the Out-of-Stack diluting sample
probe, use P/N: GS-K116.
Nickel Anti-Seize Compound -- P/N GRS-NAS-01C:
Up to 2400°F (1315°C) |
Description: For use as lubricant that protects threaded
parts from seizing and galling. Recommended for all of the
threaded parts of your probe heater.
Gasket, Heater Coil Transition -- P/N 5200.010 (cross-ref
EPM P/N 2135.215):
Description: Located on the heater coil at transition
to the inner flange assembly of the EPM model 797.560 series
in-situ dilution probe heater.
Gasket, Packing Ring -- P/N 5200.012 (cross-ref EPM P/N
Description: Located at the in-situ dilution probe's
support flange, provides rear seal between the probe and EPM
model 797.560 series in-situ probe heater.
Gasket, Packing Ring -- P/N 5200.012S:
Description: Same gasket as noted above, but produced
from orange silicone rubber for special applications.
Gasket, Mounting Flange -- P/N 5200.014 (cross-ref EPM
Description: Located between heater mounting flange
and extension ring of the EPM model 797.561 probe heater.
Gasket, Inner Flange -- P/N 5200.015 (cross-ref EPM P/N
Description: Located between inner flange assembly
and outer heater housing of the EPM model 797.560 series in-situ
dilution probe heater.
Replacement Heater Coil -- P/N 5100.252:
Description: 115VAC, 400W, 4M armored cable, coil with
integral K-type T/C. For use with ASI Model DP-060-A Series
Heater Assembly, or EPM Model 797.560 Series Heater Assembly.
Replacement parts specific to the In-situ
Replacement parts specific to the EPM Out-of-Stack
Can't find the part your looking for?
to consider when upgrading from your older EPM heaters.